Silicone rubber drain pipe heating belt waterproof performance is good, can be used for wet, non-explosive gas sites industrial equipment or laboratory pipeline, tank and tank heating, heating and insulation, can be directly wound on the surface of the heated part, simple installation, safe and reliable. Suitable for cold areas, the main function of pipeline and solar special silicone rubber electric heating belt is hot water pipe insulation, thawing, snow and ice. It has the characteristics of high temperature resistance, high cold resistance and aging resistance.
The pipe heating belt is flat, the width can be customized, respectively 20mm,25mm,30mm, etc., flexible, usually the length is 1-20M; This silicone heating belt is more flexible - it is easy to wrap around the pipe and there is good contact between the heater and the pipe surface.
Note: If your pipe heating tape is not wrapped tightly around the pipe to keep it in good physical contact, it may not protect the pipe from freezing.Pipe heating cables are typically round and long in length, and are often sold with user-installed wall plugs and end temperature sensors to allow for custom length use.
1. Material: silicone rubber
2. Voltage: 110V-230V
3. Power: 20W/M,30W/M,40W/M,or customized
4. Width of belt: 20mm, 25mm,30mm, 35mm.etc
5. Belt length: 1-20M
6. Upper temperature limit of insulation material: 200℃, upper temperature: 150℃
7. Power error: ±8%
8. Insulation resistance: ≥200 MΩ
9. Compressive strength: 1500v/5s
10. Temperature control mode: mechanical knob temperature control, digital display temperature control, temperature control box
(1) non-alkali glass fiber core frame winding electric heating wire, the main insulation is silicone rubber, good heat resistance, reliable insulation performance.
(2) Has excellent flexibility, can be directly wound on the heating device, good contact, uniform heating.
(3) When installing, the silicone rubber plane side of the electric belt should be close to the surface of the medium pipeline and tank, and fixed with aluminum tape. In order to reduce heat loss, a thermal insulation layer should be measured outside the electric belt.
(4) According to the needs of the heater, it is bent and wound at will, and the space occupation is small, simple and fast installation method.
(5) It can be combined with mechanical temperature control, digital temperature control, temperature control box, etc., which is economical and practical.
Before the inquiry,pls send us below specs:
1. Sending us the drawing or real picture;
2. Heater size,power and voltage;
3. Any special requirements of heater.
